Material Managing Electrical power UNIT 1
This electrical power unit is developed to the fork lift business, consisting of remarkably efficient gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down movement are managed by the lever on the manual release valve, which can be outfitted with an electrical switch to activate the motor. The lowing velocity is controlled from the stress compensated movement management valve.
1. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean each of the hydraulic parts concerned before set up of the energy unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which ought to also be clean and free of charge of impurities, N46 hydraulic oil is recommended .
4. Oil altering is needed following the initial one hundred operation hours, afterwards as soon as each 3000 hrs.
5. The electrical power unit proven is created to be mounted horizontally.
Material Managing Energy UNIT two
This energy unit characteristics electrical power up gravity down circuit. Activate the get started solenoid to start the motor to lift the machine. The lowing motion is activated by the solenoid valve with all the reducing speed managed through the pressure compensated movement management valve. Products of this series could be broadly used in the marketplace of logistic units such as fork lift, mini lift table, and so on.
one. The duty of this energy unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic parts concerned ahead of mounting the electrical power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities, N46 hydraulic oil is recommended .
four. Oil altering is required soon after the original 100 operation hrs,afterwards as soon as each and every 3000 hrs.
five. The energy unit needs to be mounted horizontally.