Energy UNITS FOR LIFT TABLE 1
General Description
This power unit is created exclusively for that tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be widely applied from the field of logistic gadgets such as minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve together with the speed managed from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Common Description
This energy unit is developed exclusively for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the pace controlled through the adjustable needle valve. When the lift rises to a substantial positoin, however the energy supply is minimize, the reducing movement is managed through the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is developed exclusively for the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as the pace managed by a strain compensated flow handle valve.
Power UNITS FOR LIFT TABLE 4
General Description
This power unit is developed solely for the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and also the pace managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the energy provide is minimize, the decreasing motion is managed from the guide override function.
Particular Notes
1. This electrical power unit is of S3 duty cycle, which could only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned in advance of set up of the electrical power unit.
3. Viscosity on the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is needed right after the original 100 operation hours,afterwards the moment each and every 3000 hrs.
five. The energy unit shown is created to be mounted vertically.