Consisting of a stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this power unit is designed to operate materials dealing with equipment. The reducing motion is achived through the solenoid valve with all the decreasing velocity managed by an adjustable needle valve. The left and correct functions are equipped which has a dual pilot operated test valve and cross-over relief valves.
Remark: Please seek the advice of our sales engineer to the different pump displacement, motor energy or tank capability.
one. This electrical power unit is of S3 duty cycle, i.e.,non-continuous operation,30 seconds on and 270 seconds off.
two. Clean each of the hydraulic parts concerned in advance of set up of the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which must also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
4. This power unit ought to be mounted horizontal.
5. Check the oil level inside the tank after the 1st start on the electrical power unit.
six. Oil changing is required following the initial one hundred operation hrs, afterwards after each and every 3000 hours.